genpower should use /usr/share/doc instead of /usr/doc

Binary package hint: genpower

dveeden@thinkpad:~$ sudo apt-get install genpower
Reading package lists... Done
Building dependency tree
Reading state information... Done
The following NEW packages will be installed:
  genpower
0 upgraded, 1 newly installed, 0 to remove and 0 not upgraded.
Need to get 47.3kB of archives.
After unpacking 164kB of additional disk space will be used.
Get:1 http://nl.archive.ubuntu.com feisty/universe genpower 1.0.5-2ubuntu1 [47.3kB]
Fetched 47.3kB in 0s (220kB/s)
Selecting previously deselected package genpower.
(Reading database ... 150217 files and directories currently installed.)
Unpacking genpower (from .../genpower_1.0.5-2ubuntu1_i386.deb) ...
Setting up genpower (1.0.5-2ubuntu1) ...
- Edit /etc/genpowerd.conf to set cable type, port, and to enable UPS monitor.
- Edit /etc/init.d/powerfail to set shutdown delays for this system.
- Note that genpower will not work with the smart-signalling mode supported by
  most UPS systems. You will likely have to build a special cable to make use
  of the UPS's dumb-signalling mode (if it has one). Information on this can
  can be found in the /usr/doc/genpower/cables directory. If you have an APC,
  unit you should be able to use the 'apc-pnp' cable type with the Windows-95
  PNP (plug-n-play) cable that came with your UPS. This cable should come
  with all APC Backups Pro, Smart-Ups, and Matrix-Ups systems.

/etc/init.d/genpower: UPS monitor daemon not enabled

dveeden@thinkpad:~$ dpkg -l genpower
Desired=Unknown/Install/Remove/Purge/Hold
| Status=Not/Installed/Config-files/Unpacked/Failed-config/Half-installed
|/ Err?=(none)/Hold/Reinst-required/X=both-problems (Status,Err: uppercase=bad)
||/ Name Version Description
+++-==============-==============-============================================
ii genpower 1.0.5-2ubuntu1 Monitor UPS and handle line power failures