linux-raspi 5.4.0-1027.30 source package in Ubuntu

Changelog

linux-raspi (5.4.0-1027.30) focal; urgency=medium

  * focal/linux-raspi: 5.4.0-1027.30 -proposed tracker (LP: #1910016)

  * rpi3b+ wifi doesn't get used if ethernet disconnected (LP: #1890487)
    - net: lan78xx: Ack pending PHY ints when resetting

  * focal/linux-raspi: Upstream raspberrypi patchset 2020-12-10 (LP: #1908077)
    - ARM: dts: Limit BT modem baud rate on 3B
    - configs: Enable CHACHA20POLY1305=m
    - overlays: Update i2c0 overlay to disable the i2c0mux.
    - dt: Remove duplicate assignment for i2c0 pinctrl config
    - overlays: Add option for composite to vc4-kms-v3d-pi4.
    - minor typo in directions
    - overlays: Regenerate upstream-pi4 overlay
    - overlays: Add parameters to adafruit18, sainsmart18
    - rpivid_h265: Fix width/height typo
    - overlays: Add extra CMA sizes (up to 512M)
    - overlays: Add note to BCM2711 overlays
    - overlays: adafruit18,sainsmart18: default bgr to off
    - configs: Remove I2C_BRCMSTB from the kernel
    - net: bcmgenet: Reset RBUF on first open
    - ASoC: cs42xx8: Only define cs42xx8_of_match once
    - configs: Regenerate the defconfigs
    - staging: bcm2835-codec: Use a define the completion timeout
    - staging: bcm2835-codec: Correct buffer number change on start streaming
    - USB: gadget: f_hid: avoid crashes and log spam
    - Update hy28b-overlay.dts
    - overlays: Update display GPIO declarations
    - SQUASH: USB: gadget: f_hid: remove more spam
    - configs: Add CONFIG_RTC_DRV_SD3078=m
    - overlays: Add sd3078 to the i2c-rtc overlay
    - configs: Restore SND_PCM_OSS=m
    - configs: Add MEMCG_SWAP support initially disabled
    - dwc_otg: initialise sched_frame for periodic QHs that were parked
    - arm64: configs: Enable Unicam support
    - arm64: configs: Enable V4L2 test module support
    - staging: bcm2835-camera: Replace deprecated V4L2_PIX_FMT_BGR32
    - staging: bcm2835-codec: Replace deprecated V4L2_PIX_FMT_BGR32
    - ARM: bcm2711-rpi.dts: Unlock DMA channels 9 & 10
    - gpio: Add gpio-fsm driver
    - configs: Add CONFIG_GPIO_FSM=m
    - overlays: Add fsm-demo overlay
    - overlays: Add ghost-amp overlay
    - Fixes a problem when module probes before i2c module is available
    - uapi: Update V4L2_CID_USER_BCM2835_ISP_BASE due to upstream change
    - Revert "Bluetooth: Check key sizes only when Secure Simple Pairing is
      enabled"
    - dtoverlays: Correct CSI2 settings for ov9281
    - xhci: quirks: add link TRB quirk for VL805
    - dts: Add CM4 to arm64 dt files
    - dts: Tidy the Raspberry Pi Makefile entries
    - staging: bcm2835-audio: Add disable-headphones flag
    - ARM: dts: Disable headphone audio on Zeroes, CM4
    - overlays: Enable headphone audio in audremap
    - rpisense-fb: Set pseudo_pallete to prevent crash on fbcon takeover
    - PiFi-40 defconfigs
    - PiFi-40 Devicetree files
    - PiFi-40 driver, Makefile and Kconfig
    - dwc_otg: Minimise header and fix build warnings
    - gpio-fsm: Fix a build warning
    - rpivid_h625: Fix build warnings
    - dwc_otg: Fix more build warnings
    - bcm2708_fb: Fix a build warning
    - bcm2835-pcm: Fix up multichannel pcm audio
    - watchdog: bcm2835: Ignore params after the partition number
    - firmware: raspberrypi: Add support for tryonce reboot flag
    - phy: broadcom: split out the BCM54213PE from the BCM54210E IDs
    - phy: broadcom: Add bcm54213pe configuration
    - Allo boss2 driver
    - Add allo boss2 overlay
    - Add allo boss2 config
    - Revert "mailbox: avoid timer start from callback"
    - ARM: dts: Add bcm2711-rpi-400.dts
    - overlays: Deprecate and delete the sdtweak overlay
    - overlays: Complete the sdtweak excision
    - ARM: dts: bcm27xx: Remove enable_headphones setting
    - staging: vcsm-cma: Fix memory leak from not detaching dmabuf
    - Update Allo Piano Dac Driver for 5.4.y kernels
    - Overlay: Update Allo Piano Plus dac driver for 5.4.y kernels.
    - Update volume controls in Allo Piano Dac Plus
    - can: rx-offload: can_rx_offload_add_manual(): add new initialization
      function
    - dt-binding: can: mcp25xxfd: document device tree bindings
    - can: mcp25xxfd: add regmap infrastructure
    - can: mcp25xxfd: add driver for Microchip MCP25xxFD SPI CAN
    - can: mcp25xxfd: add listen-only mode
    - can: mcp25xxfd: mcp25xxfd_handle_eccif(): add ECC related errata and update
      log messages
    - can: mcp25xxfd: mcp25xxfd_probe(): add SPI clk limit related errata
      information
    - can: mcp25xxfd: mcp25xxfd_ring_free(): fix memory leak during cleanup
    - can: mcp25xxfd: mcp25xxfd_irq(): add missing initialization of variable
      set_normal mode
    - dt-binding: can: mcp25xxfd: documentation fixes
    - dt-binding: can: mcp251xfd: narrow down wildcards in device tree bindings to
      "microchip,mcp251xfd"
    - can: mcp25xxfd: narrow down wildcards in device tree bindings to
      "microchip,mcp251xfd"
    - can: mcp251xfd: rename driver files and subdir to mcp251xfd
    - can: mcp251xfd: rename all user facing strings to mcp251xfd
    - can: mcp251xfd: rename all remaining occurrence to mcp251xfd
    - can: mcp251xfd: mcp251xfd_regmap_crc_read(): increase severity of CRC read
      error messages
    - can: mcp251xfd: mcp251xfd_regmap_nocrc_read(): fix semicolon.cocci warnings
    - can: mcp251xfd: remove unneeded break
    - mcp251xfd: add overlay
    - Add mcp251xfd driver as module to RPI build configuration
    - media: i2c: imx219: Selection compliance fixes
    - media: bcm2835-unicam: Correctly handle error propagation for stream on
    - media: bcm2835-unicam: Return early from stop_streaming() if stopped
    - media: bcm2835-unicam: Clear clock state when stopping streaming
    - ARM: dts: CM4 audio pins are not connected
    - configs: Add RTC_DRV_PCF85063=m
    - overlays: Add PCF85063 and PCF85063A to i2c-rtc
    - overlays: Fix cut-and-paste error in README
    - media: i2c: imx477: Selection compliance fixes
    - SAUCE: net: bcmgenet: Remove empty line to match upstream
    - [Config] raspi: updateconfigs after update to rpi-5.4.y 2020-12-10

  [ Ubuntu: 5.4.0-61.69 ]

  * focal/linux: 5.4.0-61.69 -proposed tracker (LP: #1910037)
  * overlay: permission regression in 5.4.0-51.56 due to patches related to
    CVE-2020-16120 (LP: #1900141)
    - ovl: do not fail because of O_NOATIME
  * Focal update: v5.4.79 upstream stable release (LP: #1907151)
    - net/mlx5: Use async EQ setup cleanup helpers for multiple EQs
    - net/mlx5: poll cmd EQ in case of command timeout
    - net/mlx5: Fix a race when moving command interface to events mode
    - net/mlx5: Add retry mechanism to the command entry index allocation
  * Kernel 5.4.0-56 Wi-Fi does not connect (LP: #1906770)
    - mt76: fix fix ampdu locking
  * [Ubuntu 21.04 FEAT] mpt3sas: Request to include the patch set which supports
    topology where zoning is enabled in expander (LP: #1899802)
    - scsi: mpt3sas: Define hba_port structure
    - scsi: mpt3sas: Allocate memory for hba_port objects
    - scsi: mpt3sas: Rearrange _scsih_mark_responding_sas_device()
    - scsi: mpt3sas: Update hba_port's sas_address & phy_mask
    - scsi: mpt3sas: Get device objects using sas_address & portID
    - scsi: mpt3sas: Rename transport_del_phy_from_an_existing_port()
    - scsi: mpt3sas: Get sas_device objects using device's rphy
    - scsi: mpt3sas: Update hba_port objects after host reset
    - scsi: mpt3sas: Set valid PhysicalPort in SMPPassThrough
    - scsi: mpt3sas: Handling HBA vSES device
    - scsi: mpt3sas: Add bypass_dirty_port_flag parameter
    - scsi: mpt3sas: Handle vSES vphy object during HBA reset
    - scsi: mpt3sas: Add module parameter multipath_on_hba
    - scsi: mpt3sas: Bump driver version to 35.101.00.00

  [ Ubuntu: 5.4.0-60.67 ]

  * Packaging resync (LP: #1786013)
    - [Packaging] update variants
    - update dkms package versions
  * CVE-2021-1052 // CVE-2021-1053
    - [Packaging] NVIDIA -- Add the NVIDIA 460 driver

 -- Kleber Sacilotto de Souza <email address hidden>  Fri, 08 Jan 2021 18:08:56 +0100