© 2004
Canonical Ltd.
•
Terms of use
•
Data privacy
•
Contact Launchpad Support
•
Blog
•
Careers
•
System status
•
0e1f616
(Get the code!)
Hi,
Well, it looks like while my device is finally working, I can only connect at 802.11G right now. I haven't played much over the holidays, but one thing I did do is set my router to allow only N connections and then I couldn't connect.
I see that Yohann's connection is connecting using 802.11N, so it must be something on my end. I'm sure I have the right flags (ie, both HAS_DOT11_N... have "Y"), but maybe I'll run through recompiling everything again and post my results.
It's also strange that my internal G card only connects at 24 while the WUSB600N connects at the full 54 MBps, but that's another problem for another day. At least I can watch my HD recordings from my MythTV without it stuttering from most of our house :-)
Redger, good to hear you've had success too!
rori, isn't the 1737:0071 the V1 of the WUSB600N? It should work with the older rt2870 driver - there's lots on google for getting that to work. In fact, I bought this device thinking it would work then found out it was a V2 with a different chipset.