Created an attachment (id=4181)
partman log AFTER attempting RAID setup
Next, what I did was enter the RAID program, tell it to create an MD device,
and then select two partitions. It only listed three of the existing four, but
I selected two that I wanted. Then tab and then enter on Continue. I then
tell it to Finish. The partitioner is reentered. It does not display the RAID
device as I had tried to set up. The attachment is the log after all of this.
Created an attachment (id=4181)
partman log AFTER attempting RAID setup
Next, what I did was enter the RAID program, tell it to create an MD device,
and then select two partitions. It only listed three of the existing four, but
I selected two that I wanted. Then tab and then enter on Continue. I then
tell it to Finish. The partitioner is reentered. It does not display the RAID
device as I had tried to set up. The attachment is the log after all of this.