Comment 14 for bug 46314

Not that simple in my case. I tried precompiled 2.6.15-22.34 kernel (and dapper's final X) and all the same as several months. glxinfo segfaulting before printing last section, any opengl app crashing X and leaving (plain 80x25) console in mess. So just a "little" change from original bug #30382.

Section Device from xorg.conf:
        Identifier "S3 Inc. 86C270-294 Savage/IX-MV"
        Driver "savage"
        Option "AGPMode" "2"
        BusID "PCI:1:1:0"

Log with 'Load "GLcore"' commented out (see bug #46661):
http://jasovi.ath.cx/Xorg.0.log
(how to attach it to this post?)

Card's lspci -vvv:
0000:01:01.0 VGA compatible controller: S3 Inc. 86C270-294 Savage/IX-MV (rev 13) (prog-if 00 [VGA])
        Subsystem: Hewlett-Packard Company: Unknown device 0014
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
        Latency: 64 (1000ns min, 63750ns max), Cache Line Size: 0x08 (32 bytes)
        Interrupt: pin A routed to IRQ 11
        Region 0: Memory at f0000000 (32-bit, non-prefetchable) [size=128M]
        Expansion ROM at 28000000 [disabled] [size=64K]
        Capabilities: [dc] Power Management version 1
                Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-
        Capabilities: [80] AGP version 1.0
                Status: RQ=32 Iso- ArqSz=0 Cal=0 SBA- ITACoh- GART64- HTrans- 64bit- FW- AGP3- Rate=x1,x2
                Command: RQ=32 ArqSz=0 Cal=0 SBA- AGP+ GART64- 64bit- FW- Rate=x2