sata_via not working anymore - kernel 2.6.20

Bug #80297 reported by luca.mg
2
Affects Status Importance Assigned to Milestone
linux-source-2.6.20 (Ubuntu)
Fix Released
High
Unassigned

Bug Description

Binary package hint: linux-source-2.6.20

Both kernel 2.6.19 (Ubuntu and Fedora) and 2.6.20 (Ubuntu) do not boot: when probing sata hardware the system is unable to correctly identify the hard disks on a system with a PCI Via VT6420 sata raid controller and a couple of Seagate hard disks. Another box with an embedded Via VT8237 sata controller and a single Maxtor HD does not boot with the same malfunction too. Please see http://bugzilla.kernel.org/show_bug.cgi?id=7641 and/or http://bugzilla.kernel.org/show_bug.cgi?id=7415 as I could not explain it any better.

Revision history for this message
luca.mg (luca-mg) wrote :

I may add that these very same computers where working fine with both Ubuntu kernel 2.6.17 and Fedora 2.6.16.

Revision history for this message
luca.mg (luca-mg) wrote :

With the feisty 2.6.2.-rc6 kernel sata via is back to normal! However I downloaded the stable 2.6.20 kernel and compiled it with the feisty 2.6.20-rc6 config file and the resulting kernel would go past the sata via initialization but will stop at the raid initialization stage. Compiled again with no raid support results in a fully booting kernel.

Revision history for this message
Ben Collins (ben-collins) wrote :

Thanks for the update.

Changed in linux-source-2.6.20:
importance: Undecided → High
status: Unconfirmed → Fix Released
Revision history for this message
luca.mg (luca-mg) wrote :

Ben, thank You for Your attention. Of course there's a typo in my last post: "2.6.2.-rc6" should read "2.6.20-rc6", moreover I'm running 2.6.20-8-generic i686 at the moment and it is fine so far.

To post a comment you must log in.
This report contains Public information  
Everyone can see this information.

Other bug subscribers

Remote bug watches

Bug watches keep track of this bug in other bug trackers.