I'm running, or trying to run, an Optra E310 in 7.10 (I think).
I had selected the Optra E310 driver. No go: dies with the "inode permission" bug.
I tried stopping apparmor, with no better luck.
I then tried "generic PostScript foomatic" driver: no go.
I then tried "generic PostScript" (non-foomatic) driver.
This sort of works, but a fair number of documents make
the printer light blink for a few seconds, then the yellow
printer error light blanks, then the rest is silence.
The job is then marked as "completed". I would guess this
means the generic PS driver is buggy.
I'm running, or trying to run, an Optra E310 in 7.10 (I think).
I had selected the Optra E310 driver. No go: dies with the "inode permission" bug.
I tried stopping apparmor, with no better luck.
I then tried "generic PostScript foomatic" driver: no go.
I then tried "generic PostScript" (non-foomatic) driver.
This sort of works, but a fair number of documents make
the printer light blink for a few seconds, then the yellow
printer error light blanks, then the rest is silence.
The job is then marked as "completed". I would guess this
means the generic PS driver is buggy.
On one of the above, dmesg gets:
[17972.993541] lp0: ECP mode
messages. Not sure if that's good or bad.
Suggestions/ recommendations welcome.
Robert