sudo hdparm -i /dev/sdb Password:
/dev/sdb:
Model=SAMSUNG SP0802N , FwRev=TK100-24, SerialNo=S00JJ10X390473 Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs } RawCHS=16383/16/63, TrkSize=34902, SectSize=554, ECCbytes=4 BuffType=DualPortCache, BuffSize=2048kB, MaxMultSect=16, MultSect=?16? CurCHS=4047/16/255, CurSects=16511760, LBA=yes, LBAsects=156368016 IORDY=on/off, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120} PIO modes: pio0 pio1 pio2 pio3 pio4 DMA modes: mdma0 mdma1 mdma2 UDMA modes: udma0 udma1 *udma2 udma3 udma4 udma5 udma3 udma4 udma5 AdvancedPM=no WriteCache=enabled Drive conforms to: ATA/ATAPI-7 T13 1532D revision 0: ATA/ATAPI-1 ATA/ATAPI-2 ATA/ATAPI-3 ATA/ATAPI-4 ATA/ATAPI-5 ATA/ATAPI-6 ATA/ATAPI-7
* signifies the current active mode
I did a clean install recently, so this is the default udam2 but then as given above in the comments my hdd supports ATAPI-5
I thought that was the way, but can do this way also.
sudo hdparm -i /dev/sdb
Password:
/dev/sdb:
Model=SAMSUNG SP0802N , FwRev=TK100-24, SerialNo= S00JJ10X390473 16383/16/ 63, TrkSize=34902, SectSize=554, ECCbytes=4 DualPortCache, BuffSize=2048kB, MaxMultSect=16, MultSect=?16? 4047/16/ 255, CurSects=16511760, LBA=yes, LBAsects=156368016 240,w/IORDY: 120}, tDMA={min: 120,rec: 120}
Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs }
RawCHS=
BuffType=
CurCHS=
IORDY=on/off, tPIO={min:
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 *udma2 udma3 udma4 udma5 udma3 udma4 udma5
AdvancedPM=no WriteCache=enabled
Drive conforms to: ATA/ATAPI-7 T13 1532D revision 0: ATA/ATAPI-1 ATA/ATAPI-2 ATA/ATAPI-3 ATA/ATAPI-4 ATA/ATAPI-5 ATA/ATAPI-6 ATA/ATAPI-7
* signifies the current active mode
I did a clean install recently, so this is the default udam2 but then as given above in the comments my hdd supports ATAPI-5
I thought that was the way, but can do this way also.