Comment 60 for bug 192720

same than chongma : load is ok, scan is ok but I can't connect
Presario R3215 : Broadcom Corporation BCM4303 (rev 02)

here is the dmesg modprobe b43legacy and then try to connect :
[ 9770.120955] ssb: Core 0 found: IEEE 802.11 (cc 0x812, rev 0x02, vendor 0x4243)
[ 9770.120965] ssb: Core 1 found: PCMCIA (cc 0x80D, rev 0x00, vendor 0x4243)
[ 9770.120974] ssb: Core 2 found: Fast Ethernet (cc 0x806, rev 0x02, vendor 0x4243)
[ 9770.120982] ssb: Core 3 found: V90 (cc 0x807, rev 0x01, vendor 0x4243)
[ 9770.120991] ssb: Core 4 found: PCI (cc 0x804, rev 0x03, vendor 0x4243)
[ 9770.124362] ssb: Sonics Silicon Backplane found on PCI device 0000:02:02.0
[ 4881.698311] b44.c:v2.0
[ 4881.698331] b44: Invalid MAC address found in EEPROM
[ 4881.698335] b44 ssb0:1: Problem fetching invariants of chip, aborting.
[ 4881.699227] b44: probe of ssb0:1 failed with error -22
[ 4881.717462] b43legacy-phy0: Broadcom 4301 WLAN found
[ 4881.744374] b43legacy-phy0 debug: Found PHY: Analog 0, Type 1, Revision 4
[ 4881.744400] b43legacy-phy0 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2
[ 4881.767887] b43legacy-phy0 debug: Radio initialized
[ 4881.769041] phy0: Selected rate control algorithm 'simple'
[ 4882.158614] udev: renamed network interface wlan0 to wlan1
[ 4883.159840] b43legacy-phy0 debug: Loading firmware version 0x127, patch level 14 (2005-04-18 02:36:27)
[ 4883.258541] b43legacy-phy0 debug: Chip initialized
[ 4883.259086] b43legacy-phy0 debug: 30-bit DMA initialized
[ 4883.260902] b43legacy-phy0 debug: Wireless interface started
[ 4883.266295] b43legacy-phy0: Radio hardware status changed to disabled
[ 4883.266679] b43legacy-phy0 debug: Adding Interface type 2
[ 4883.267251] ADDRCONF(NETDEV_UP): wlan1: link is not ready
[ 9837.600296] wlan1: Initial auth_alg=0
[ 9837.600308] wlan1: authenticate with AP xx:xx:xx:xx:xx:xx
[ 9837.800098] wlan1: authenticate with AP xx:xx:xx:xx:xx:xx
[ 9838.000036] wlan1: authenticate with AP xx:xx:xx:xx:xx:xx
[ 9838.199962] wlan1: authentication with AP xx:xx:xx:xx:xx:xx timed out
[ 9852.141114] wlan1: Initial auth_alg=0
[ 9852.141128] wlan1: authenticate with AP xx:xx:xx:xx:xx:xx
[ 9852.339822] wlan1: authenticate with AP xx:xx:xx:xx:xx:xx
[ 9852.539781] wlan1: authenticate with AP xx:xx:xx:xx:xx:xx
[ 9852.739704] wlan1: authentication with AP xx:xx:xx:xx:xx:xx timed out