ok i am a real lightweight but i have done some work and this is what i found
on this release CUPS does not start! i found a post on the forum
sudo /etc/init.d/cupsys start
and it worked on 7.04 and 6.10(live cd) and i could configure my printer ( if i knew the admin password and username for a live cd)
but on gg tribe 5 live cd i get this message "cannot apply additional memory protection after relocation"
hope this helps some?
ok i am a real lightweight but i have done some work and this is what i found
on this release CUPS does not start!
i found a post on the forum
sudo /etc/init.d/cupsys start
and it worked on 7.04 and 6.10(live cd) and i could configure my printer ( if i knew the admin password and username for a live cd)
but on gg tribe 5 live cd
i get this message
"cannot apply additional memory protection after relocation"
hope this helps some?