Knot 3 doesn't enable eth0 for VIA Rhine 2 II VT6102

I just installed knot3 on one of my machines. But my network card was not added as eth0.

lspci
Code:

00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 70)

lspci -vv
Code:

00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 70) Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32, Cache Line Size: 32 bytes Interrupt: pin A routed to IRQ 11 Region 0: I/O ports at e400 [size=256] Region 1: Memory at e6003000 (32-bit, non-prefetchable) [size=256] Capabilities: [40] Power Management version 2 Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0 PME-

ifconfig
Code:

lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:2 errors:0 dropped:0 overruns:0 frame:0 TX packets:2 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:100 (100.0 b) TX bytes:100 (100.0 b) wlan0 Link encap:Ethernet HWaddr 00:0D:2F:00:58:98 inet addr:192.168.1.100 Bcast:192.168.1.255 Mask:255.255.255.0 inet6 addr: fe80::20d:2fff:fe00:5898/64 Scope:Link UP BROADCAST RUNNING MTU:1500 Metric:1 RX packets:3739 errors:0 dropped:0 overruns:0 frame:0 TX packets:1852 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:1437725 (1.3 MiB) TX bytes:244500 (238.7 KiB)