Install -- Raid setup cannot see all of my RAID partitions
Bug #22301 reported by
Timothy Miller
This bug affects 3 people
Affects | Status | Importance | Assigned to | Milestone | |
---|---|---|---|---|---|
partman-md (Ubuntu) |
Triaged
|
Medium
|
Unassigned |
Bug Description
Using daily build from 9/21
I set up two RAID partitions (physical volume) on one large drive and one RAID
partition on each of two smaller drives. Then I went to bolt them together in
the RAID setup. The first time, it only saw one of my RAID partitions. I quit
back to the partitioner and then tried again, and now it only sees three of the
four.
Earlier, I was seeing some sort of error reported where the partitioner could
not inform the kernel of the partition changes. I'm not getting that error this
time, but perhaps it's related?
Changed in partman: | |
status: | Unconfirmed → Confirmed |
Changed in partman-md: | |
assignee: | kamion → nobody |
To post a comment you must log in.
Also note that if I tell it to setup software RAID and select two of the
partitions, they don't get recorded. That is, when I go back to the
partitioner, it has no listing of any md volumes. I had done a setup before,
where I only had three RAID partitions, and I was able to setup RAID. But now
that I have four, it's gotten very confused.
Rebooting seems to help with some of these partitioning problems, but not this time.
BTW, I'm trying to setup RAID0, but not a single RAID0 of four, but rather two
of two.